Computer cd tray wont open


computer cd tray wont open

You'll know robin hood treasures game this is the case by the noise if you gently tilt the drive back and forth.
Below, I'm opening the DVD drive out of a Sony Vaio, but the tray didn't spring out when the paperclip pushed in the release, which you can tell by feel.
If not, you should try reseating the drive in the bay.Unlike your DVD player for your TV or your stereo CD player, the disc in your computer drive may be much more valuable than the drive itself.Copyright 2010 by Morris Rosenthal, all Rights Reserved, copyright 2010 by Morris Rosenthal -All Rights Reserved contact info.The printable eBook version of The Laptop Repair Workbook is now available for download anywhere in the world.But there are instances in which the emergency release won't get the tray to eject.Gently pull the drive out.If you look closely, youll almost certainly see a small hole in the drives front panel.If the disc in the drive plays OK, you know that the power and the connector are fine.Start by unbending a leg of the largest diameter paperclip that will fit in the hole on the faceplate of the drive.Carefully try to maneuver the disc so that its sitting where it should.Try closing a few obvious culprits.In either case, the odds of the drive being salvageable aren't very good, but if it was a label failure, you should be able to rescue the disc by disassembling the drive around it until the tray ejects or the disc is accessible.Or, better yet, reboot the computer.The drive should pop slightly open.And before you rush out and buy a supposed generic replacement for the drive, remember that while the connector may be standard, the drive shell is customized, and you may not be able to transfer all of the shell hardware from one drive to another.About the worst thing it can be is if the motor or gear train failed, which would mean replacing the drive.Another possibility is that an adhesive label peeled off in the drive and has gummed up the works.Sometimes an important CD or DVD gets stuck inside the drive, and the tray just wont open.Next, insert it it straight into the hole, and if you're lucky, there will bee a little click before it goes in very far, and the tray will pop out a fraction of an inch.So I had to pull on it with my fingernail behind the plastic facade while depressing the release.
If that wont work, try to find a way to remove the disc without ruining either the disc or the drive.




Sitemap